Myq garage myq home bridge and myq smart garage hub erase the wi fi settings.
Reset wifi garage door opener.
Hold down a button on your remote garage door opener.
In order to do a factory reset you need to locate the yellow learn button on your ceiling wi fi garage door opener.
It s located on the back or side of the motor unit.
Wait for both the oblong and circular led to light up blue before they switch off altogether.
Within 30 seconds of pressing the learn button press down on a button on the remote.
This will send out a radio signal to the ceiling mounted motor unit.
In the future when the unit receives that specific signal it will open the garage door it s attached to.
The green led must be on or flashing to erase the wi fi settings press and hold the settings gear button on the side of the hub until the blue led starts flashing.
This calibrates the opener and syncs it with your remote control.
To reset the wi fi garage door opener back to the factory default settings see.
There is a yellow antenna wire hanging from the same side the learn button is located on.
To reset the system you will need to locate the button on the motor that reads learn or home in many cases this button will be located on the same side as the device s antenna and next to an led.
Push down the same button on your garage door remote.
Or for a wall mounted wi fi garage door opener.