Remove the door panel to gain access.
Replacing inner door handle.
If the knob is to the right select a right handed door.
Then repeat these steps for installing all of your new interior doors.
Open the door and stand with your back to the hinges.
Insert a sharp object into the latch hole if there aren t visible screws.
Traditional doorknobs will have two screws in.
Check door for proper operation.
Inspect door latch and replace if not working.
The strike side the side with the lockset of these doors has a beveled edge so the door can swing freely.
You should feel a small indentation or hole.
Let s take some time to go over these steps so you ll be ready to replace that faulty or dated knob with a new one that functions properly and has the look you want.
Woodie s will show you how to change a door handle.
Pull the interior knob away.
The price of handle is nothing if compared with the price of door but it really adds value.
Loosely reinstall the inner door panel.
Carefully detach them remove the broken handle and replace it with the new one.
Pry off the door pull trim piece with a flat blade screwdriver pry off the trim piece at the front top corner of the door panel with a flat blade screwdriver remove the two 10mm bolts on the door pull remove the 10mm bolt inside the door handle.
Remove the screws in the faceplate of the doorknob if they re visible.
Screw on the hinges.
Use a self centering hinge bit to ensure that the screws remain centered as you drive them.
Removing the doorknob 1.
In this video i show you how to replace the interior door handle for a 2006 2011 chevy hhr.
Then install the new door in the doorframe.
How to remove the old door handle.
Remove and replace the broken door handle.
A highly price wooden door will lose its value if low quality solemn looking internal door handle is used.
Then secure the hinges in place with screws.
Unscrew any nuts or bolts holding the door handle in place.
A drill may also be helpful.
Some blank doors have a specific swing direction.
Mark the center of each screw hole.
If the doorknob is on the left you need a left handed door.
There will be a rod from the inner door handle to the door latch mechanism usually held together by plastic clips.