When the door is lowered the spring winds up tightly creating a pulling force that helps lift the door up.
Pulled safety now garage door wont open.
Check the door s electric eye.
Do not stand under the door.
Make sure it is hanging down from the motor.
You might be out of range.
Pull the emergency release cord.
If your garage door is closing fully and then reversing to open again then it may be due to a problem with the close limit switch.
The antenna on the motor could be damaged or blocked from the signal.
If your garage door is stuck in the open position please contact precision door of spokane immediately so we can fix your door before serious damage occurs.
If it is working properly your door should close or open without any problems.
Now if your garage door stops opening up before it gets to 5 feet you ll need to adjust the open or up force nob.
If it is still not working recheck the connection at the top.
If it doesn t budge then try pulling on the red cord again.
If the door opens with the wall switch a simple battery change in the remote should do the trick.
We have 24 7 emergency services just for situations as hazardous as this.
In the funniest of scenarios the problem will simply be due to an unplugged power cord.
Use a screwdriver to tighten the wire.
When your garage door won t open with the remote there are few things that can cause this problem.
In order to fix this you ll want to make small changes to the close limit setting until the door opener knows to stop once the door has reached the floor.
Many garage doors have a powerful torsion spring located horizontally above the door.
It will come crashing down and could cause some damage.
Shut off the power to the garage door opener.
This is the emergency disconnect that will release the door.
You might have absentmindedly unplugged the operator as you were exiting the garage through your internal door to the house.
Do not attempt this if the door is wide open.
You ll also want to make sure you keep the trolley about 2 to 4 inches from the protection bolt.
Do not pull so tight that you damage the cord or the lever.
Turn the power back on and the door should open and close normally.
You may want to pull the cord the other way to see if that works.
Pull the cord to release it.
Sometimes a garage door won t open or close for one reason only the operator has no power connection.
